1/1

57 絞り品のフランジ首部の肉溜りとヒゲバリ 57 Metal accumulation and whisker-like burrs at the drawn flange neck

57 フランジ首部の肉溜りとヒゲバリ.pdf

¥400 税込

ダウンロード販売の商品
購入後にDL出来ます (1100111バイト)

プレス加工される絞り加工製品でフランジのある製品は少なくないですが、工程間の寸法設定、特にボリューム調整をうまくしないと、フランジの首の部分に余肉が溜まったり長いヒゲバリが出てしまって対処に苦労することがあります。今回、このフランジ首部に生じる肉溜りとヒゲバリの発生原因について説明し、基礎的な対処法を説明しました。しかし、これらの方法で解決する場合とそうでない場合があります。これらを根本的に解決するには全く別の考え方を使った方法(P204、非公開)で対応することが必要です。
Not a few deep-drawn press products have flanges, but if dimensional setting between processes, especially volume adjustment, is not done properly, excess material can accumulate in the neck of the flange or long whisker-shaped burrs can occur. These can be difficult to eliminate. In this article, I have explained the causes of these problems and described basic methods of dealing with them. However, these methods may or may not solve the problem. To solve these problems fundamentally, it is necessary to deal with them by using a completely different approach (P204, undisclosed).

  • お支払い方法について

¥400 税込

最近チェックした商品
    その他の商品